RADIAL J48 48V PHANTOM
RADIAL J48 48V PHANTOM
| Product Code: | RADIAL J48 48V PHANTOM |
| Availability: | In Stock |
-
RM1,250.00
RM1,089.00
- Ex Tax:RM1,089.00
0 reviews Write a review
- Welded I-beam construction makes it impossible to torque the PC board. This virtually eliminates cold solder joints - the No.1 cause of system failure in the field.
- An innovative 'slide-in-place' XLR trace makes it possible to use I-Beam girder construction.
- A digital switching power supply steps-up the internal rail voltage to 9-Volts. The J48 will not choke like other DI's when hit with large transients.
- A military-grade PC board is employed for maximum wear and tear in abusive environments. Welded steel standoffs ensure the PC board will not shift.
- A -15dB pad allows super hot inputs such as that from a CD player to be connected and balanced for long runs.
- Momentary 48V Check LED will flash once when the 80Hz filter is depressed to tell you phantom power is present.
- The Merge function turns the input & thru into 'left & right' inputs to mono mix at the XLR output. This handy function saves valuable inputs on the mixer!
- The input is connected to the instrument.
- The thru-put is connected to the instrument amplifier. The JDI has a high input impedance to reduce loading.
- Our book-end design creates a protective zone around the switches & connectors for best protection!
- A heavy-duty baked enamel finish for excellent durability and great looks for years! 100% 14-gauge steel construction.
- The 600 Ohm balanced XLR out is mic level to properly match concert splitters - will drive 1000 feet without appreciable noise.
- A polarity reverse switch flips the polarity from the AES standard Pin-2 to Pin-3 on the XLR and is used when combining sounds that may be out of phase.
- An 80Hz low-cut (highpass) filter gently reduces excessive bass for more headroom and clarity. Eliminates run-away resonant feedback from acoustics!
- The ground-lift disconnects the ground path to the transformer at the XLR output. This is used when a ground path is made at the input side such as with a keyboard.
- A no-slip full bottom pad reduces mechanical vibration, improves electrical isolation and keeps the JDI from moving around on busy stages!